UG-003 Innovative New Design GPS Antenna

Features

  • RF protection in front-end , protect any kind of receives in the GPS market.
  • Standard WAAS tune from our antennas
  • Short-circuit protection as standard design
  • Wide power supplier voltage from +2.5~12V
  • Narrow band-width<=30 MHz.
  • Cable can be up to >10 meters even for small patch antenna.

UG-003 GPS Antenna is the only innovating design antenna with performance, quality and a Power protection circuit built-in to protect the active LNA’s, and most importantly the host GPS receiver down the connector end from the danger of a SHORT circuit external antenna (Note: GPS receiver front-end can be destroyed or de-graded by an external GPS antenna in an over-load or short conditions. The UG-003 is a low profile GPS active antenna system for the next generation multi-purpose GPS mobile antenna products for Telematics, Fleet Management, Navigations and AVL applications. This small print size of the antenna design does not reflect over-all performance, since the antenna itself needs no ground plane aid to deliver the L1 band small signal carrier that originates from the 24 orbiting USA satellites located thousands of miles over-head and with the ground reception power sensitivity at over -130dB. The UG-003 antenna is also design as a standard power input voltages in range from +2.5Vdc to +12Vdc with reverse polarity shutdown, over-current sense shutdown and an EMC power line suppression. The most important over-all design concept of the UG-003 active antenna is the complete protections of the host sensitive GPS receiver made from any manufacturer that it serve and can also be destroy or de-grade using an improper design antenna.

Specification
General 
   2 Stages active LNA 
   Dual Filters, (HPF & LPF(lump element)) 
   +28dB gain 
Architecture Design Dielectric Patch antenna 
Low Noise Low drop-out, Linear Regulator 
GPS receiver short circuit protect 
Low Loss RG/174 Coax cable 
Aluminum Base/ PC+ Radome Plastic 
Performance
Receiving Frequency  L1 Band(1575MHz) 
Output Impedance  50 ohms 
Polarization’s  Right Hand Circular (RHC) 
Bandwidth  10dB Mhz @ -3dB point 
VSWR  1.5 Typical @ 1575MHz 
Elev. Angle Coverage  5~90 degree 
Az. Bearing Coverage  360 degree 
Filterin  Dual(BPF <10 Mhz B/W, LPF @1576 MHz Stop-band @ 1585MHz) 
Over-all Gain  28dB (typical including 4dB cable loss & Filters) 
Over-all NF  <1.8dB @fo, 2dB max. 
LNA Characteristic  K=>1 Un-conditionally Stable 
RF Insertions loss  0.1dB, leakage power 100mW /1 watt input 
Power Consumption  5 to 11mA (max) 
Power Input Sensor  Reverse Polarity Short Circuit shutdown 
Over-Current Sensor  Thermal Over-current shutdown >+150degreeC 
Physical 
Dimensions  44 x 34 x 12mm +/-0.5mm 
Mount  Magnetic 
Radome Color  Black 
Coax Connector  BNC, SMA, SMB, MCX, MMCX, GT-5 
Coax Cable  RG-174U double shielded 5m, Low Loss 0.7dB/m 
Environmental 
Operating emperature  -30 to + 85 degreeC 
Storage  -40 to + 90 degreeC 
Option
OEM Hardware  1. Open Frame Antenna , with RF shield 
2. Open Frame with 3” Flanges & RF shield 
3. Ant + Aluminum Base 
Electrical 
Power Input  +2.5Vdc to +12Vdc input, AutoSwitch 
E-mail Telephone contact